Cupra Formentor VZ5 RX1 exhaust flap control

Flap control RX1 for the Cupra Formentor VZ5

Suitable for the following Cupra models:

• Cupra Formentor VZ5 from model year 2020-

With this control unit you have the option of manually switching your exhaust flaps. The control is done using a hand-held transmitter. This gives you full control over your vehicle sound!

Advantages compared to competing products

Control independent of Drive Select

You decide on the vehicle sound and not the selected driving profile

Correct series mode (module deactivated) even after vehicle start

Important for visits to the workshop, service or TÜV.

Freely programmable start mode

You decide what sound you want when you start your vehicle

No interference with the CAN bus

No danger to other control units

No influence of software updates on the function of our control

Plug and Play with original plugs

No damage to the original cables, no use of power thieves

The device offers the following modes:

Start mode:

The start mode describes the mode in which the device should start after the ignition is switched on. In the standard configuration, the device saves the last mode set and restores it when the vehicle is started. If you want a specific mode when starting, regardless of how you parked your vehicle, this can be programmed.

The start mode can be freely programmed as desired

Last state: Press the “Sport Mode” button 5 times within 5 seconds.

Other modes: Press the button for the mode you want to learn as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm successful programming of the start mode.

Assembly

Installation is plug and play in the footwell behind the A-pillar trim (instructions are included in delivery). Installation time approx. 30-45 minutes.

Additional features:

Can be retrofitted at any time without leaving any traces

No interference with the standard CAN bus

No error message in the error log

Handheld transmitter

High quality and elegant appearance

brushed stainless steel front

High range

This device has been specially developed for use with electrical flap systems and therefore offers safe and long-lasting operation.

Rely on our quality!

Branded product Made in Germany!

Hints

No approval in the StVO

For racing use only

When driving at full load, the flaps should not be completely closed

Installation at your own risk

If the instructions are not followed, no liability is accepted for any damage caused

We receive a large number of custom orders and inquiries daily, so it is not always possible for us to have every item in stock at all times. If you need the item urgently, please contact our sales team here to check the stock before making your purchase.

We completely understand if you are unsure whether a part is compatible with your car. We therefore strongly recommend that you contact us here with your inquiry . Our friendly sales team will then contact you to confirm if this part is the correct part you are looking for.

All our products come with a standard 2 year warranty. However, this depends on the type of product. Further details can be found here .

At Upgrade my Car (R-Trade GmbH) we attach great importance to informing our customers comprehensively about the intended use of our products. Please note that unless otherwise stated, all of our products are specifically designed for professional racing use. These are intended solely for use in competition on circuits approved by an officially recognized racing organization. Please note that any use of our products other than these Terms, including recreational off-road driving, may potentially violate local, state or federal law. It is important to understand that Upgrade my Car (R-Trade GmbH) assumes no liability for the legality of using our products on public roads. The responsibility for compliance with applicable laws lies solely with the buyer. We strongly recommend that our customers familiarize themselves with the relevant legal regulations and comply with them before using our products.